Combustion in Diesel Engines

August 27, 2015 Jaz Comments 2 comments

Combustion in diesel engines takes place in three distinct phases.

First Phase of Combustion

Ignition delay period is the time span between commencement of fuel injection and the start of fuel ignition. The fuel emerges into the cylinder as small liquid particles, which are surrounded by hot compressed air. They receive heat from the air and more volatile constituents of the fuel vaporize. During the ignition delay period a large part of the fuel charge is prepared for combustion. During the ignition delay, the injector continued to inject the fuel and, if this has built up a sufficient quantity, the rapid combustion and pressure rise will be quite violent, causing detonation and shock loading creating a noise termed diesel knock. After ignition commences flame propagation proceeds very quickly in the fuel vapour or air mixture, accompanied by rapid temperature and pressure rise. Towards the end of the rapid pressure rise a point is reached where the rate of pressure rise falls away quickly, and the curve flattens out towards the maximum pressure point. The point where the rate of pressure rise changes near and approaching the maximum pressure point is the end of the second phase of combustion. This shows only a small pressure rise, as the rate is decreased due to downward movement of the piston. The end of injection occurs approximately at or slightly beyond the maximum pressure point. Combustion in diesel engines can be termed as a ‘controlled explosion’.

Second Phase of Combustion

Rapid or uncontrolled combustion usually occur just after the ignition of the fuel vapours.

combustion in diesel engines — Combustion in Diesel Engines

Start of Injection
Beginning of Ignition
Maximum Pressure
End of Injection
End of Ignition
End of After Burning

1 – 2 : Ignition delay period, 2 – 3 : Rapid / Uncontrolled Combustion, 2 – 4 : Ignition Period, 3 – 4 : Controlled Combustion, 5 – 6 : After Burning

Third Phase of Combustion

Controlled combustion is regulated by the rate at which fuel continues to be delivered.

After Burning

After burning is said to occur when the third phase of combustion extends over a long period. It may be caused by incorrect fuel grade, bad atomization, poor or excess penetration, incorrect fuel temperature, incorrect injection timing, insufficient air supply, or any combination of these. Slow burning, high viscosity, high density, high carbon content fuels may also cause after burning of a serious nature leading to engine damage.

Effect of After Burning

After burning creates high exhaust temperatures and may cause overheating of the engine in severe cases. Some drop in the maximum firing pressure usually accompanies this. There is a loss of thermal efficiency when after burning occurs, due to greater loss of heat to exhaust gases and the transfer of large amount of heat to the cooling water. There is a risk of damage to exhaust valves and scavenge fires.